Showing posts with label zii. Show all posts
Showing posts with label zii. Show all posts

Zii Battery Box

So I cut out a battery box for the Zii... After checking with Andreas, I trimmed the foam on the indentations of the front box at the front and back edges.  White PU for attachment.  I set the front and back boards of the box such that they would transfer shock along the side and bottom boards.  I routed out some battery strap slots (the middle one by hand, in case you can't tell).
Initial box cut, a little bit tall.  I whittled it down with a fresh-bladed box cutter.
Not too bad.  Fits snugly in the slot.
Oh no!!  It's just a bit too narrow for the 3S 3000's!  It's pushing one side out... That will affect the structural integrity in a crash, so I may recut the box.
Here's the batteries snugged in and tied down.  Will talk to Andreas about the best place to put the APM, receiver, and ESC.

Zephyr II and ArduPilot Layout

Here's a few notes by Andreas on laying out a Zii with an Ardupilot Mega.

This is his first Zii.  One 5000 mAh 3S or one 3000 mAh 4S battery is placed sideways at the nose.








In his second Zii, he started with a plywood battery box.  He cut this himself; it's sized to hold two 4000 mAh 3S Turnigy Nano batteries.











To keep the radio components separated, he:

  • moved the video transmitter all the way to the winglet
  • put the RC receiver is in the center of the wing on the opposite side
  • put 3DR radio close to the APM in the main compartment
He mounted the ESC above the APM.

Zii Battery Tray by Team Blacksheep

Trappy explains:  "the battery bay is there to make your ZII durable. on our tests we dived in vertical from 30 meters on purpose. the forces get spread evenly and the 6mm plywood takes most of the beating, protecting the battery and the ZII. Use lots of gorilla glue when glueing it in, the glue will enter through all these tiny holes in the ZII Bay and make it really strong."

Product page here, forum discussion here.  Lots of detail from Trappy, be sure and check it out!

Zephyr II glued up!

Got the body glued up... wasn't quite sure what I was doing with the 3M 90, but it went not too badly.  That stuff is sticky.  I got some on my hand and had to wait for the next day for it to wear off.
I didn't get good coverage on the tips, but a bit of epoxy seems to have set things right.
I followed Chris' video for the motor mount installation.  It worked well.  I used a skinny hacksaw blade, so the motor mount was a bit of a tight fit and caused some cracking of the foam.  A bit of epoxy set things right.  Next time, I'll use a fatter blade, or make extra passes with the skinny blade to hollow the slot out a bit more.
Older Post ►
eXTReMe Tracker
 

Copyright 2011 Hobby-RC s is proudly powered by blogger.com